A soldering jig and base for 6 x 6 LED grid modular lamps.
See here for stable download: https://thangs.com/mythangs/file/40230
This base was designed around the dimensions of the 12VDC LED strips in the diagram above. There is some bridging in the object, so be sure your printer is capable and calibrated appropriately!
Cut the LEDs into sections of 6 LEDs per strip
On one end of the strip, protect the negative contact point with electrical tape and solder a 1.5 cm bare wire on the positive contact point. Do the opposite for the other end. Do this with all strips. See picture above.
Place the LED strips in the soldering jig ensuring that the positive contacts are on one side and the negative contacts are on the other. Run your main positive and negative leads up each side and solder to each strip. Ensure that the LED strips do not shift. See picture above.
Peel the adhesive backing off of the LED strips and press the bottom cover on top to adhere to the LED strips.
Here are other modules that use the same LED base:
"Dendrite" https://www.thingiverse.com/thing:4340529
"Out After Dark" https://www.thingiverse.com/thing:4332088
"Among the Ruins" https://www.thingiverse.com/thing:4322049
"Penguins on Ice" https://www.thingiverse.com/thing:4321879
"Rabbits in Forest" https://www.thingiverse.com/thing:4321943
"Stonehenge" https://www.thingiverse.com/thing:4321731
Check back later for links to more customized lamps!
