AIRLESS VOLLEYBALL

Hello,
This is a truly impressive ball. You don't need to inflate it or worry about it getting punctured.
The thickness of the ball has been carefully calculated by me to be suitable for all sizes you print, limiting breakage when you play.

You will get:
- STL file.

I hope you will like it!

FDM:
- 70-80° support angle in Cura or Manual support painting in Bambulab. You must turn on support only "Touching buildplate" in setting 
- No need infill support.
- 0.28mm layer for big print.
Resin:
- You just need to put support at the bottom of the ball.