AIRLESS BASKETBALL - STL & 3MF MULTICULOR

Hello,
This is a truly impressive ball. You don't need to inflate it or worry about it getting punctured.
The thickness of the ball has been carefully calculated by me to be suitable for all sizes you print, limiting breakage when you play.

You will get:
- STL file.
- 3mf file colored in bambulab studio, orca slicer software.

I hope you will like it!

3D PRINTING SETTINGS
If you want good bounce, you should print with hard materials: PLA or hard TPU.

FDM:
- 70-80° support angle in Cura or Manual support painting in Bambulab. You must turn on support only "Touching buildplate" in setting (I have included 3mf file wth support in bambulab)
- No need infill support.
- 0.28mm layer for big print.
Resin:
- You just need to put support at the bottom of the ball.