Low Poly Plant - Snake Plant

The leaves for this snake plant also work well as bookmarks. You can fold them more or less depending on how vertical you want the leaves.

I have Ironing enabled for the leaves, but you may disable it if you'd like to save some time (Process>Global>Ironing>Ironing Type: No Ironing).

If you're prone to having adhesion issues I'd recommend printing with a build plate temp of at least 60C. You may also need to print fewer leaves at once since the edge of the build plate can have low spots/worse adhesion.

You should be able to scale this print up or down a bit, but you'll want to make sure to not scale the leaves in the Z direction.

These settings are already applied: Initial Layer Height: 0.16mm Layer Height: 0.2mm

Filament used: Polymaker PLA Jungle Green

Polymaker PLA PRO Light Green

Polymaker PLA PRO Army Beige

Generic Black PLA