Pokémon Pikachu Diy IEM Earphone

Pokémon Pikachu Diy IEM Earphone

This is a  "D I Y"  IEM Earphone, After you print all model component out, you need to buy some electrical stuff to assemble it.

The 3D printer i am using is Phrozen  mini 8ks  with Phrozen Aqua Resin-Snows Gray 8K for white parts, Hyperfine Graphite Black parts , Aqua Clear Plus for Clear parts but mixing with Red liquid dye.

This is what you need to buy

1. The speakers 9mm  MT009B -Foster Electric ,(If you want to use another speaker must make sure is same size as this one.)

2. Some  Litz-Wire , About 8cm will be enough for you welding the speakers and 2 pin female socket jack connector 

(If you want to use another wire also must make sure is not too thick.)

3. 2 Pin Female socket jack connector pin diameter 0.78 mm (Spec in the picture above)

4. A Audio Cable with 2 pin 0.78mm connector interface